Shopsmith Forums

Left Door Storage.jpg

on this picutre could you add a close up on how you mounted the tables?

I remember nick mentioning in one of the sawdust session using a slightly different angle for sharpening the blades. He quoted someone from the shop telling him a certain angle was better. Does anyone know which session this might be or remember the angle? I know it is different than what the planer ...

Can some one tell me were to find the rip fence alignment? I have looked through the manual a few times and must be missing it. :confused: ok, I found the thread that said there is none and to loosen the 4 screws on top keeping one snug, dang mine are super tight any thought on how to loosen them up ...

Was wondering if on the horizontal/vertical feather board if you used a toilet bolt? Any help with hardware would be appreciated?

Thanks
Greg

Until today I have always been pleased with customer service. I waited on the phone for 20 minutes and then at 5:02 PM. The message changed and said the are only open to 5 PM EST and it hung up on me. Is this normal? I am sure the ones answering the telephone have no control over this but you would ...

[[attach]2507[/attach]

[attach]2508[/attach]

[attach]2509[/attach]

[attach]2510[/attach]

Does anyone have a suggestion for were to purchase 12" PSA disk of higher grit 320, 400, 600 etc?

WOuld like to have this for sharpening.

I think I remember a post for a jig for drilling pen blanks. It was a V-block that was used in the horizontal boring position. If anybody knows where it is please post the link.


I think this is what you are looking for

http://groups.yahoo.com/group/penturners/files/Jigs%20and%20Tools/Drill ...

Thanks nick,

The veener jig you said that they had 1/8 round and 1/4 round. Maybe I am making it to complicated, did you just cut the cross braces free hand or did you use and arc or circle jig to complete them?

Great thanks Bob, That is more clear or less murky