Shopsmith Forums

It came from my dad, I haven't had a chance to use it at all yet but it looks like it will do the job it was built for, nice and thick, t-mitre slot etc. I will build a unit for it to sit in permanently that's the same height as my bench (when I've built that too) then I can use that for support for ...

yes, that's the one

Hi Charles, The fence part number is 515511, the router table is 555658.

it is essentially 2 bits of angled ali with slots, I've had a little think about it, I need to go and double check holes/slots etc. but perhaps using a flat base piece going across the 2 fences would allow offset adjustment ...

Hi all, I have been given a shopsmith mark V router table and router fence, I am having issues trying to figure out a way to easily offset the outfeed fence from the infeed whilst keeping everything level, the fence arrived with a single bit of mdf attached to each of the of the 2 pieces of ...