Here's the guide I was following for my planer knife setting jig.
http://wiki.vintagemachinery.org/Getting%20Peak%20Planer%20Performance.ashx
Since I can't adjust my cutterhead, rollers, bed, or anything else, I just focused on the knives. I set them 0.032"above the lowest point of the infeed roller. My cutterhead was in perfect parallel with the bed, but I found the infeed roller was 0.015" out of parallel with the bed.
Simple Jigs
Moderator: admin
Heath
Central Louisiana
-10ER - SN 13927, Born 1949, Acquired October 2008, Restored November, 2008
-10ER - SN 35630, Born 1950, Acquired April 2009, Restored May 2009, A34 Jigsaw
-Mark V - SN 212052, Born 1986, Acquired Sept 2009, Restored March 2010, Bandsaw
-10ER - SN 39722, Born 1950, Acquired March 2011, awaiting restoration
Central Louisiana
-10ER - SN 13927, Born 1949, Acquired October 2008, Restored November, 2008
-10ER - SN 35630, Born 1950, Acquired April 2009, Restored May 2009, A34 Jigsaw
-Mark V - SN 212052, Born 1986, Acquired Sept 2009, Restored March 2010, Bandsaw
-10ER - SN 39722, Born 1950, Acquired March 2011, awaiting restoration
New Jig
I use quite a bit of plywood with solid wood edging. I have a flush trim jig that I've used for years but I decided that after looking at this one in ShopNotes (Issue 125) that it would be a lot easier to use. I'm really happy with it after a couple of projects.
In these pictures I'm removing dowel pin ends that were cut proud.
One of the great things about making jigs, and I'm sure most of you will agree, is that after years of this hobby you have whatever you need on hand for something like this. I did need 4 - 20mm screws to attach the jig to the router but I had a nice walk to the hardware store, stopped for a coffee a MacDonalds and then headed home.
[ATTACH]19583[/ATTACH]
[ATTACH]19584[/ATTACH]
[ATTACH]19585[/ATTACH]
[ATTACH]19586[/ATTACH]
[ATTACH]19587[/ATTACH]
In these pictures I'm removing dowel pin ends that were cut proud.
One of the great things about making jigs, and I'm sure most of you will agree, is that after years of this hobby you have whatever you need on hand for something like this. I did need 4 - 20mm screws to attach the jig to the router but I had a nice walk to the hardware store, stopped for a coffee a MacDonalds and then headed home.
[ATTACH]19583[/ATTACH]
[ATTACH]19584[/ATTACH]
[ATTACH]19585[/ATTACH]
[ATTACH]19586[/ATTACH]
[ATTACH]19587[/ATTACH]
- Attachments
-
- IMG_1610.jpg (52.26 KiB) Viewed 1665 times
-
- IMG_1607.jpg (53.49 KiB) Viewed 1667 times
-
- IMG_1608.jpg (24.21 KiB) Viewed 1664 times
-
- IMG_1609.jpg (28.74 KiB) Viewed 1664 times
-
- IMG_1612.jpg (35.41 KiB) Viewed 1664 times
New Leaf Custom Woodworking
Berry Conway - Chief Dust Maker
Berry Conway - Chief Dust Maker
