Oh and THIS time I unplugged the SS, so even If I did touch the back of the switch. I wouldn't have to pull my hand out quickly and rip it on the align tang.
I tried it
Moderator: admin
I tried it
SOMEWHERE here I was reading about lubing the pork-chop. I used a little bit of squeeze out from a wax ring and applied it to the gear. Ran the speed up and down a couple times. The dial moves much easier now, won't know about if it attracts dust or not for awhile.
Oh and THIS time I unplugged the SS, so even If I did touch the back of the switch. I wouldn't have to pull my hand out quickly and rip it on the align tang.
Oh and THIS time I unplugged the SS, so even If I did touch the back of the switch. I wouldn't have to pull my hand out quickly and rip it on the align tang.
SS 500(09/1980), DC3300, jointer, bandsaw, belt sander, Strip Sander, drum sanders,molder, dado, biscuit joiner, universal lathe tool rest, Oneway talon chuck, router bits & chucks and a De Walt 735 planer,a #5,#6, block planes. ALL in a 100 square foot shop.
.
.
Bob
.
.
Bob
I'll bet that was a shocking experiance!:Dbeeg wrote:SOMEWHERE here I was reading about lubing the pork-chop. I used a little bit of squeeze out from a wax ring and applied it to the gear. Ran the speed up and down a couple times. The dial moves much easier now, won't know about if it attracts dust or not for awhile.
Oh and THIS time I unplugged the SS, so even If I did touch the back of the switch. I wouldn't have to pull my hand out quickly and rip it on the align tang.
Octogenarian's have an earned right to be a curmudgeon.
Chuck in Lancaster, CA
Chuck in Lancaster, CA