I hope this is in the correct section of the forum.
The following link was a great help to me when I started out with the Shopsmith. I originally bought the SS as a lathe then realized what I had.
http://www.seafoamwoodturning.com/Sites ... urning.htm
Check out the first line...
"Introduction to Woodturning - an e-book for beginners. "
I hope this is useful. please read the copyright notice.
Regards
Sandy
Lathe ebook for free
Moderator: admin
-
sandyj
- Gold Member
- Posts: 75
- Joined: Mon Feb 18, 2008 6:03 pm
- Location: Auckland, New Zealand
- Contact:
Lathe ebook for free
1960 SS500, Magna Jointer & Dado. Hailing from New Zealand
-
pinkiewerewolf
- Platinum Member
- Posts: 526
- Joined: Mon Jan 07, 2008 10:13 pm
- Location: Ca. Eureka area.
Sandy, thanks for the link. Very useful info for somone such as I, that hasn't turned a lathe since High School.
John, aka. Pinkie. 1-520, 1-510 & a Shorty, OPR. 520 upgrade, Band Saw, Jig Saw, scroll saw, Jointer, Jointech Saw Train.
Delta Benchtop planer, Makita LS1016L 10" sliding compound miter saw, Trojan manf. (US Made)Miter saw work center, MiniMax MM16 bandsaw.
Squire of the Shopsmith. ...hmmmm, maybe knave, pawn, or wretch would be more appropriate for me.
Delta Benchtop planer, Makita LS1016L 10" sliding compound miter saw, Trojan manf. (US Made)Miter saw work center, MiniMax MM16 bandsaw.Squire of the Shopsmith. ...hmmmm, maybe knave, pawn, or wretch would be more appropriate for me.