Cutting dowels, tubing, pipe, (cylinders) Square
Moderator: admin
Wow.
Thanks everybody.
All good ideas, and I can see where my 'gadget' budget is going. Determined to finally get this off my back. A decent miter box, tubing cutter, replace my backsaw (I think I shouldn't have used it that time to cut rebar- somehow it just wasn't the same after that), and work out a serious band saw & table saw setup.
Obviously it can be done, and I just hafta get my mind around doing it up right.
No more hold the pipe on my knee, grab that old pruning saw...
Appreciate the inspiration.
Thanks everybody.
All good ideas, and I can see where my 'gadget' budget is going. Determined to finally get this off my back. A decent miter box, tubing cutter, replace my backsaw (I think I shouldn't have used it that time to cut rebar- somehow it just wasn't the same after that), and work out a serious band saw & table saw setup.
Obviously it can be done, and I just hafta get my mind around doing it up right.
No more hold the pipe on my knee, grab that old pruning saw...
Appreciate the inspiration.
Mark V 520, Power-Pro!; Speed Reducer; B/S; Jointer; ShopMate DCS; SS Tenon Master; Rip-Strate; Incra; BCTW; DW734; var. SS sanding systems; Wood River;
Table saw? Dang, last time I tried it with the TS it ... wait...garys wrote:For plastic and wood, I just hack them off with the table saw. Straight cuts in seconds.
B O I N G ! !
I didn't have--- The SLED!
oh boy,
Mark V 520, Power-Pro!; Speed Reducer; B/S; Jointer; ShopMate DCS; SS Tenon Master; Rip-Strate; Incra; BCTW; DW734; var. SS sanding systems; Wood River;