Mark V Model 500 Shaper Mode

JPG · Post by **JPG** » Mon Mar 10, 2014 3:38 pm

What Doug did not reveal, was that in addition to that being a 520, it also has a Power Pro headstock.

That embedded message re doing this with a Mark V was a bit misleading due to its lack of detail. The Mark V must be a 505/510/520 and the conversion requires a double tilt upgrade, and a power pro headstock.

A 500 would also require a table upgrade.

anmius · Post by **anmius** » Mon Mar 10, 2014 4:28 pm

unwavering wrote: My question is the 500 able to do this over the table?

To answer your specific question, yes the "500" can do over the table shaping. I do it all of the time. Here is the section from Power Tool Woodworking for Everyone to help you set it up:
http://www.shopsmith.com/academy/shaping/index.htm

JPG · Post by **JPG** » Mon Mar 10, 2014 6:02 pm

anmius wrote:To answer your specific question, yes the "500" can do over the table shaping. I do it all of the time. Here is the section from Power Tool Woodworking for Everyone to help you set it up:
http://www.shopsmith.com/academy/shaping/index.htm

Missed that word!:o