Rip fence and floating table

SDSSmith · Post by **SDSSmith** » Mon Apr 07, 2014 7:13 pm

beeg wrote:WHY wood ya avoid that? I use one on each end for long board support.

Drill press set up and being able to center chuck over insert. I do not think that would be possible with the insert 4-1/2" to the right due to a table on the left. Packy is talking about bolting them on to the main table.

SDSSmith · Post by **SDSSmith** » Mon Apr 07, 2014 7:16 pm

beeg wrote:WHY wood ya avoid that? I use one on each end for long board support.

Drill press set up and being able to center chuck over insert. I do not think that would be possible with the insert 4-1/2" to the right due to a table on the left. Packy is talking about bolting them on to the main table.

packy · Post by **packy** » Mon Apr 07, 2014 7:17 pm

All good points....
Just a thought, suppose the best way would be to just upgrade to a new table system.
Thanks all for your most valuable input.
Tim

JPG · Post by **JPG** » Mon Apr 07, 2014 7:29 pm

SDSSmith wrote:Drill press set up and being able to center chuck over insert. I do not think that would be possible with the insert 4-1/2" to the right due to a table on the left. Packy is talking about bolting them on to the main table.

That also!:D