Pulleys for Power Station

tvhorman · Post by **tvhorman** » Fri May 16, 2014 4:47 pm

I'm new to posting to the forum however I have been monitoring it for some time.
I obtained a power station, used and in working condition, however I do not know the various pulley sizes and belts needed for the various SPT's I could put on it. Could someone point me in the right direction please? A preliminary search didn't show me anything I could use. Thanks.

BuckeyeDennis · Post by **BuckeyeDennis** » Fri May 16, 2014 4:58 pm

Welcome!

If you need to change pulleys for different SPT's, then what you have is likely a "Power Stand", not a "Power Station", in Shopsmith lingo.

Check here for an SPT pulley chart, on page 2.

tvhorman · Post by **tvhorman** » Fri May 16, 2014 5:12 pm

Thanks, that is exactly what I was looking for. Yes I did get a power stand.
Thanks:)

JPG · Post by **JPG** » Fri May 16, 2014 6:17 pm

tvhorman wrote:Thanks, that is exactly what I was looking for. Yes I did get a power stand.
Thanks:)

I suggest you copy/print that info for future reference.

I am!:D

BuckeyeDennis · Post by **BuckeyeDennis** » Fri May 16, 2014 8:04 pm

For the record, now that I am back home with my paper manuals, I can add that the old-style 18" jigsaw uses the same set of pulleys as the bandsaw.

Shopsmith Forums

Pulleys for Power Station

Pulleys for Power Station

My bad