Where to purchase wood?
Moderator: admin
Where to purchase wood?
My usually projects require small pieces of wood, which I often get from old furniture, by internet purchase, or while traveling. Now I have an itching to create the outdoor server featured in Wood Magazine July 2008. The material list calls for 1x8's and 2-4x4's. They list ceder, but I was thinking of quarter-sawn oak. I have a bunch of big box stores around, but most of the fine lumber yards are long gone. Even fine dry redwood is hard to find locally. Anyone in SoCal with suggestions? What do you guys do? Thanks, Gary
Gary Kalyn
Kalynzoo Productions
Woodworking
Porter Ranch/Northridge
Los Angeles, CA
Kalynzoo Productions
Woodworking
Porter Ranch/Northridge
Los Angeles, CA
- curiousgeorge
- Platinum Member
- Posts: 880
- Joined: Tue Feb 27, 2007 1:00 am
- Location: Fort Worth, Texas
Hi Gary,
I would suggest sticking with the cedar for any outdoor furniture. It's cheaper and is best for outdoor use, not to mention it is a very attractive wood when finished. Otherwise you might check here for a wood source:
http://woodfinder.com/
I would suggest sticking with the cedar for any outdoor furniture. It's cheaper and is best for outdoor use, not to mention it is a very attractive wood when finished. Otherwise you might check here for a wood source:
http://woodfinder.com/
George
Ft. Worth, TX.
Go TCU Froggies
Ft. Worth, TX.
Go TCU Froggies
-
paulmcohen
- Platinum Member
- Posts: 1578
- Joined: Fri Dec 08, 2006 8:10 pm
- Location: Beaverton, Oregon
- Contact:
kalynzoo wrote:The material list calls for 1x8's and 2-4x4's. They list ceder, but I was thinking of quarter-sawn oak. I have a bunch of big box stores around, but most of the fine lumber yards are long gone. Even fine dry redwood is hard to find locally. Anyone in SoCal with suggestions? What do you guys do? Thanks, Gary
I made several outdoor pieces out of cedar fence boards purchased at Lowes. I just picked through what they had a picked the best, then rank them through my planer, jointer and saw. I ended up with beautify wood very cheap.
Paul Cohen
Beaverton, OR
A 1982 500 Shopsmith brand upgraded to a Mark 7 PowerPro, Jointer, Bandsaw (with Kreg fence), Strip Sander, Ring Master and lots of accessories all purchased new
12" Sliding Compound Mitre Saw, 1200 CFM DC
Beaverton, OR
A 1982 500 Shopsmith brand upgraded to a Mark 7 PowerPro, Jointer, Bandsaw (with Kreg fence), Strip Sander, Ring Master and lots of accessories all purchased new
12" Sliding Compound Mitre Saw, 1200 CFM DC
I'd stick with the cedar, too, for outdoor furniture. I just completed an outdoor patio table from Woodsmith magazine. It looks really nice. I finished it with Cabot Australian Timber Oil from Lowe's. I purchase the lumber at a local lumber yard. The boards were clear and straight. I would check a lumber yard that sells to local builders since they buy a lot for decks, etc.
Bruce
Bruce
Gary,
Reconsider redwood for outside furniture. It makes a piece of furniture look rich and handsome. The only knock I have with it is it's really soft wood and dents easily. Easy to mill and sands easily. Side by side it makes cedar look ordinary and "everyone has it". Redwood is not cheap but the results are fantastic.
In San Diego, J&W Redwood is the best. However, a little secret. The bigger 2X material found at HD or Lowe's when planed down can reveal some beautiful useful redwood. Give it a try.
Bob
San Diego
Reconsider redwood for outside furniture. It makes a piece of furniture look rich and handsome. The only knock I have with it is it's really soft wood and dents easily. Easy to mill and sands easily. Side by side it makes cedar look ordinary and "everyone has it". Redwood is not cheap but the results are fantastic.
In San Diego, J&W Redwood is the best. However, a little secret. The bigger 2X material found at HD or Lowe's when planed down can reveal some beautiful useful redwood. Give it a try.
Bob
San Diego
Hi Gary! Hey! Don't forget about White Oak as an outside wood! It is teriffic for Porch Swings and the like. However it is heavier than the conifers, and not for outdoor stuff you'd want to move around.kalynzoo wrote:I have a bunch of big box stores around, but most of the fine lumber yards are long gone. Even fine dry redwood is hard to find locally. Anyone in SoCal with suggestions? What do you guys do? Thanks, Gary
As far as a source for wood - I believe you hail from Northridge - There is a good source, just a hop skip and a jump south of you. http://www.woodfinder.com/listings/002801.php However, I see they have recently changed their ordering procedure. They used to offer small orders, but not have a minimum of 150 BF. They have been very helpful in the past, - Am having to call them for more 5 quarter rough poplar. Would have to clean the shop for 150BF.
Octogenarian's have an earned right to be a curmudgeon.
Chuck in Lancaster, CA
Chuck in Lancaster, CA
- a1gutterman
- Platinum Member
- Posts: 3653
- Joined: Tue Jan 09, 2007 12:45 am
- Location: "close to" Seattle