lathe chisel rack

[tomsalwasser]

Greetings fellow sawdust makers.

I decided to take the lathe chisels that I own but have never used and put them out where I will see them every day, in the hope that I will start turning. I acquired these chisels over the years in the "boxes of stuff" that accompanied 2 used Shopsmith purchases and a Craftsman table saw. I used a 10 foot piece of pvc and a few wood scraps for these racks. I think the pvc really made a mess of my saw blade.

[rjent]

What an outstanding idea! Looks good ....

Dick

[rpd]

Very nice.

I was thinking just yesterday that I needed to make a rack for my lathe chisels, and this design looks like a quick and easy solution.

Turning is lots of fun. Try it, I think you will like it.

ps Where I live the black pipe is made of ABS, the PVC is white.

[tomsalwasser]

Thanks Dick and Ron. I copied a design that Mr. Google showed me. I like your first pen Ron, I hope to make one soon. How do you sharpen your chisels?

I did not realize that I bought abs pipe, not pvc. I wonder if there's much difference when used as intended for plumbing?

[JPG]

Thanks Dick and Ron. I copied a design that Mr. Google showed me. I like your first pen Ron, I hope to make one soon. How do you sharpen your chisels?

I did not realize that I bought abs pipe, not pvc. I wonder if there's much difference when used as intended for plumbing?

There is! pvc = cold/waste cpvc = hot abs=waste

[dusty]

I did not realize that I bought abs pipe, not pvc. I wonder if there's much difference when used as intended for plumbing?

Check your local area building codes!!!

There are locations where ABS can be used only for DWV (drain/waste/vent).

http://www.ppfahome.org/abs/absgeneral.aspx

Be aware that there are version of PVC that is not potable.

[rpd]

Thanks Dick and Ron. I copied a design that Mr. Google showed me. I like your first pen Ron, I hope to make one soon. How do you sharpen your chisels?

I did not realize that I bought abs pipe, not pvc. I wonder if there's much difference when used as intended for plumbing?

You've got to love Mr. Google.

Did see the pens and wands I did this past weekend?

For sharpening I use a 1" sander/grinder that I bought at Lee Valley,

[ATTACH]25910[/ATTACH]

but just use what ever sharpening equipment you have, a bench grinder, belt sander, strip sander or disk sander should all work if set up properly.

So far I have mostly used the skew, at first it was hard work and hard to control but after I got it sharpened and honed properly it cuts easily with a light touch.

To sharpen and hone the skew I do it like Cap'n Eddie
sharpskew, Skew Sharpening tactics and close-up on skews

He also has several videos on pen turning.

Another site I found recently is the Tiny Trailer Workshop, this is one of his videos. #37 How I turn an Ebony penhttp://www.shopsmith.net/forums/www.youtube.com/watch?v=6feLTjF35z4&list=UUlek5Vj9XQWnQQQB73uAaRQ