Birthday wall plaque

ExtraMile · Post by **ExtraMile** » Tue Oct 13, 2015 12:11 am

Special order. Live edge, spaulted, red oak.

Since this type of plank was requested, the length of plank I had, would not support the letter 'S' I ran out of board length.

The customer is pleased, thus far.

The holes, under the months letters will receive key rings and wooden nickles for each birthday individual, they will dangle from the key rings!

The wooden nickles will be cut from slices of one inch dowel.

And yes, the 'T' is meant to look like a 'Cross' since this piece is for a Pastor friend!

Beave2012 · Post by **Beave2012** » Tue Oct 13, 2015 1:08 am

Looks nice. I take it you used a router with a stencil pattern and brass bushing to do it? Or am I missing some super cool trick?

I'll be amazed if you say freehand with a plunge router. lol

JPG · Post by **JPG** » Tue Oct 13, 2015 2:30 am

Beave2012 wrote:Looks nice. I take it you used a router with a stencil pattern and brass bushing to do it? Or am I missing some super cool trick?

I'll be amazed if you say freehand with a plunge router. lol

Consider thyself amazed!

ExtraMile · Post by **ExtraMile** » Tue Oct 13, 2015 6:46 pm

Freehand with el-cheapo HF trim router! No plunge, no brass bushing!

ExtraMile · Post by **ExtraMile** » Mon Oct 19, 2015 4:15 am

ExtraMile wrote:Freehand with el-cheapo HF trim router! No plunge, no brass bushing!

Well now I have a far nicer router. A PC 892, with a fixed base and plunge.

I also bought a PC edge guide

A length of T Track and a 3 drawer base cabinet stand.

Oh and for the bonus 12.8 bdft of Bubinga.

All for $280.