Using a SS Joiner w/Long stock

mwhizz · Post by **mwhizz** » Thu Dec 10, 2009 7:10 pm

I clean the end up with a router. The SS RAS worked too but the router made a much cleaner finnish. What is the longest stock for the SS Joiner. for genrail edge or surface cuts? THANKS to ALL.

jimthej · Post by **jimthej** » Thu Dec 10, 2009 10:53 pm

mwhizz wrote:I clean the end up with a router. The SS RAS worked too but the router made a much cleaner finnish. What is the longest stock for the SS Joiner. for genrail edge or surface cuts? THANKS to ALL.

As long as you have space and infeed/outfeed support for. I once did 12 foot oak rabbetted 1/4" by 3/4" under both edges.
Next time I will add a 1/4" spacer underneath.

mwhizz · Post by **mwhizz** » Sat Dec 12, 2009 1:53 pm

Thank you every one. I cleaned up the edge with the SS RAS & a craftsman router. I do need the build some fences for wide work.