How is your shop setup?

cv3 · Post by **cv3** » Sun Sep 19, 2010 9:40 pm

Having a small shop set up and storage space is limited. I found that wire shelving offered a cheap and versatile system for storage. I have used much of one wall. Wall area above tools and window. I have been very pleased with the amount of storage I have found. I have suspended the wider shelves with chain from the ceiling for lumber storage .
[ATTACH]10439[/ATTACH]

[ATTACH]10440[/ATTACH]

[ATTACH]10441[/ATTACH]

[ATTACH]10442[/ATTACH]

[ATTACH]10443[/ATTACH]

cv3 · Post by **cv3** » Sun Sep 19, 2010 9:42 pm

This is my mime lathe station.

[ATTACH]10444[/ATTACH]

burkhome · Post by **burkhome** » Mon Sep 20, 2010 11:38 am

Anybody got their portable air compressor plumbed into a cabinet permanently. I have a 4hp/ 11 gallon oilless compressor I use for my nail guns. As you know oilless units are loud. I want to build a cabinet in an adjacent storage room and plumb a couple of quick connects in the shop.

Thinking about insulation in the cabinet to further soundproof. Worried about heat and air flow.

tom_k/mo · Post by **tom_k/mo** » Mon Sep 20, 2010 1:11 pm

cv3 wrote:This is my mime lathe station.

[ATTACH]10444[/ATTACH]

OK, now that's sharp. Well done.