Page 2 of 3
Posted: Thu Jan 16, 2014 1:55 pm
by BuckeyeDennis
Here's a special jig for making wooden hinges. It incorporates multiple drill bushings to keep the bit from wandering. The link has some nice how-to photos as well.
Posted: Thu Jan 16, 2014 4:37 pm
by reible
That is the jig I used for this project:
http://www.shopsmith.net/forums/showpos ... ostcount=9
The hole size is 1/8" and you use 1/8" dia brass rod for the pin.
Ed
BuckeyeDennis wrote:Here's a special jig for making wooden hinges. It incorporates multiple drill bushings to keep the bit from wandering. The link has some nice how-to photos as well.
Posted: Thu Jan 16, 2014 5:07 pm
by harveydunn
Thanks Ed. What is the "joint matic" you refer to in the linked post?
Posted: Thu Jan 16, 2014 5:18 pm
by robinson46176
If you can find a board 100' long you can drill an accurate hole (or holes) in either end of it.
.
Posted: Thu Jan 16, 2014 5:48 pm
by reible
Shopsmith use to make them, in the most basic terms it is a horizontal router table.... Now if you want want you would have to shop the used market.
This is the link to the whole post:
https://forum.shopsmith.com/viewtopic.php?p=27139
Ed
harveydunn wrote:Thanks Ed. What is the "joint matic" you refer to in the linked post?
Posted: Thu Jan 16, 2014 7:40 pm
by algale
harveydunn wrote:Thanks everyone.
What else do you use the horizontal borer for?
JPG - interesting idea about the "faux knuckles". How would you secure the ends of the pins that are not visible?
Edge joining boards with dowels (to make a table top for example) is another classic use for horizontal boring.
Posted: Thu Jan 16, 2014 8:50 pm
by JPG
algale wrote:Edge joining boards with dowels (to make a table top for example) is another classic use for horizontal boring.
I would still have a dowel in the outer knuckles.
If Ya wanna go totally blind, use springs for the pin. one in each end. Compress the spring into the blind hole, then slip the knuckles in. Tricky, once together, that's all!!!!
I do like that jig!
Posted: Thu Jan 16, 2014 11:48 pm
by charlese
Another use of horizontal boring - Using a router bit to make mortises.
or where an odd-shaped piece needs drilling
Posted: Fri Jan 17, 2014 12:50 am
by forrestb
When making my quilt rack, I needed to bore holes for the dowel attaching the stretcher to the legs. I would have spent hours trying to design a jig to position the workpiece correctly for an upright drill press. The SS solved it right away.
Forrest
[ATTACH]23800[/ATTACH]
Posted: Fri Jan 17, 2014 7:53 am
by JPG
Boring into an edge/end rather than a face.
i.e. large surface(face) flat to the table.
With the ss(in horizontal mode) the quill is perpendicular to the edge/end.
In drill press mode, the quill is perpendicular to the face.