My bad.
1956 Mark V
Moderator: admin
-
pinkiewerewolf
- Platinum Member
- Posts: 526
- Joined: Mon Jan 07, 2008 10:13 pm
- Location: Ca. Eureka area.
I'm sorry, I should have said top guard when I was referring to the table saw.
My bad.
My bad.
John, aka. Pinkie. 1-520, 1-510 & a Shorty, OPR. 520 upgrade, Band Saw, Jig Saw, scroll saw, Jointer, Jointech Saw Train.
Delta Benchtop planer, Makita LS1016L 10" sliding compound miter saw, Trojan manf. (US Made)Miter saw work center, MiniMax MM16 bandsaw.
Squire of the Shopsmith. ...hmmmm, maybe knave, pawn, or wretch would be more appropriate for me.
Delta Benchtop planer, Makita LS1016L 10" sliding compound miter saw, Trojan manf. (US Made)Miter saw work center, MiniMax MM16 bandsaw.Squire of the Shopsmith. ...hmmmm, maybe knave, pawn, or wretch would be more appropriate for me.
mark v 1954
not so lucky as some of you all mine has some problems. the floating sheave that conects to the speed changer has a bulge in the shaft, the speed changer has no teeth on it left, the motor sheave next to the spring seems to have a bulge on it also. does this mean i need a new shaft where the eccentric bushing goes because the bushing is off to the left quite a bit to where the shaft is bending the vent screen on the outside. i hope i can find this thread again after i get out.