Page 2 of 2
Posted: Wed Feb 13, 2008 10:32 pm
by pinkiewerewolf
I'm sorry, I should have said top guard when I was referring to the table saw.
My bad.
mark v 1954
Posted: Thu Apr 17, 2008 9:37 pm
by ralphtaff
not so lucky as some of you all mine has some problems. the floating sheave that conects to the speed changer has a bulge in the shaft, the speed changer has no teeth on it left, the motor sheave next to the spring seems to have a bulge on it also. does this mean i need a new shaft where the eccentric bushing goes because the bushing is off to the left quite a bit to where the shaft is bending the vent screen on the outside. i hope i can find this thread again after i get out.