JPG
That's what I heard and why I posed my response as a question. I have never seen a straight set. With straight legs how does one perform left/right adjustments to align the drive hubs? Strikes me as being difficult to say the least.
Bill V
Very basic Power Station setup question
Moderator: admin
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: Very basic Power Station setup question
In the case of the jointer(very short tubes) adjusting the cutter mounts was 'suggested'.wa2crk wrote:JPG
That's what I heard and why I posed my response as a question. I have never seen a straight set. With straight legs how does one perform left/right adjustments to align the drive hubs? Strikes me as being difficult to say the least.
Bill V
That was to accommodate idler shaft eccentric locations.
For the spts that connect to the upper shaft, . . . . It was assumed they would align.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Re: Very basic Power Station setup question
The early tubes do not have the off set. The first picture is a complete adapter set for mounting MK V SPTs on the 10ER. It came with straight tubes. The jig saw with the Magna logo has straight tubes. At some point Magna transitioned to the eccentric tubes as the SS logo jig saw shows.wa2crk wrote:JPG
That's what I heard and why I posed my response as a question. I have never seen a straight set. With straight legs how does one perform left/right adjustments to align the drive hubs? Strikes me as being difficult to say the least.
Bill V
- Attachments
-
- DSCF0889 (640x480).jpg (258.91 KiB) Viewed 2473 times
-
- IMAG0222.jpg (160.81 KiB) Viewed 2473 times
-
- IMAG0223.jpg (138.4 KiB) Viewed 2473 times
John & Mary Burger
Eagle's Lair Woodshop
Hooper, UT
Eagle's Lair Woodshop
Hooper, UT