Posted: Fri Mar 11, 2011 6:55 pm
Failed???? I thought it was cute!:) I also appreciate the effort that went into it!dusty wrote:No! It is a failed attempt at trying to be cute.
Shopsmith Forums
A woodworking forum for woodworking hobbyist and woodworking projects related and unrelated to the Shopsmith MARK V
http://forum.shopsmith.com/
Taper Jig Question
Page 3 of 3
Posted: Fri Mar 11, 2011 7:19 pm
Well the legs I made this way (and continue to) have the table apron mortised into the legs. Very strong and was simply the way they did the pieces I copy. No butt joint in this. The leg was only tapered below the width of the table apron.
Now that I see the picture of what you are doing (or someone is) yes, I'm actually making those exact boxes right now. They are called Plyo boxes (in my world) and are varying heights from 12 to 48 inches tall with a top on them. They are used for plyometrics at our gym. I do use a similiar jig but different. Think of cross cut sled that has a 10 degree cut tapered triangle fixed to the normally 90 degree fence. This gives me my 10 degree taper on the board for the first cut, then flip for the second. And yes, for plyo boxes I am using a biscuited butt joint with screws. It's not federal furniture after all.
Now that I see the picture of what you are doing (or someone is) yes, I'm actually making those exact boxes right now. They are called Plyo boxes (in my world) and are varying heights from 12 to 48 inches tall with a top on them. They are used for plyometrics at our gym. I do use a similiar jig but different. Think of cross cut sled that has a 10 degree cut tapered triangle fixed to the normally 90 degree fence. This gives me my 10 degree taper on the board for the first cut, then flip for the second. And yes, for plyo boxes I am using a biscuited butt joint with screws. It's not federal furniture after all.
Thanks to all for the input
Posted: Sat Mar 12, 2011 9:33 am
Let me try to explain further.. but i think the answer is here.
The windmill has 6 sides. I am not cutting bevels as I am using dowels to cover the joint.
I think the answer is to make the first cut at 5 degrees and then just double it for the second. I'll give that a try and see what happens.
chester
The windmill has 6 sides. I am not cutting bevels as I am using dowels to cover the joint.
I think the answer is to make the first cut at 5 degrees and then just double it for the second. I'll give that a try and see what happens.
chester
Posted: Sat Mar 12, 2011 11:12 am
That'll do CMCC1! That'll do!cmccarter1 wrote:Let me try to explain further.. but i think the answer is here.
The windmill has 6 sides. I am not cutting bevels as I am using dowels to cover the joint.
I think the answer is to make the first cut at 5 degrees and then just double it for the second. I'll give that a try and see what happens.
chester
