Page 1 of 4
My attempt at a bowl from a board ....
Posted: Fri Dec 27, 2013 10:01 pm
by 2centsworth
My first bowl from a board using the Ringmaster. Wow and I did it ! A little complicated to get setup angles and stuff but once locked in it is a blast. Not Fred's caliber but a bowl non the less and from a board !
[ATTACH]23564[/ATTACH]
Now we are talking. Watch out with a little practice who knows what I can make. I love my Shopsmiths and this Ringmaster.
Another View
Posted: Fri Dec 27, 2013 10:06 pm
by 2centsworth
Another view
[ATTACH]23565[/ATTACH]
Not bad for a newbie.
Posted: Fri Dec 27, 2013 10:16 pm
by JPG
Keeping those rings in one piece could not have been simple! Good Job!
Posted: Sat Dec 28, 2013 12:12 am
by fredsheldon
Your hooked
Posted: Sat Dec 28, 2013 6:04 am
by newportcycle
Very nice great job, cant wait to see what else you come up with.
Posted: Sat Dec 28, 2013 8:08 am
by idcook
It’s beautiful.
From a board...
Posted: Sat Dec 28, 2013 9:23 am
by 2centsworth
Here is the picture of the board when cut.
[ATTACH]23566[/ATTACH]
It is amassing to see how it transforms.
Posted: Sat Dec 28, 2013 10:43 am
by farley
Nice job, have not tried rings for bowls yet.
Posted: Sat Dec 28, 2013 10:54 am
by JPG
It is amazing to me that none of the rings broke considering the 'species' used!
Pine to practice on ...
Posted: Sat Dec 28, 2013 11:14 am
by 2centsworth
Suggested pine as a first couple attempts less expensive and on a slow speed cuts like a hot knife thru butter.