Page 1 of 1
New Acquisition and some questions
Posted: Mon Jan 20, 2014 5:26 pm
by pieceseeker
Proud owner of a very clean, little used 520. I was able to acquire it for $1000. I think it's a good deal, only a very small amount of rust on the tubes. Best thing is, I didn't have to travel far like I have for some of my other SS stuff. It was located in my hometown. It didn't come with any extra's other than about 4 saw blades, extra saw arbor, and a sanding disk. I've got all that other stuff anyway. I didn't bother with a picture, because as a craiglist seller when asked to post a pic said "it looks like a shopsmith". Well, mine does too.
Anyway, now that I have 2 SS's, I see a shorty in my future. My question is, are the 500 tables of any use to keep?
Posted: Mon Jan 20, 2014 5:57 pm
by terrydowning
Depends on what you want your shorty to do.
If you leave it set up as a 12" sander with occasional use as a horizontal boring machine then yes.
Only you can answer this.
IIWM I would set it up as a shorty and keep the table for the flexibility if nothing else.
Posted: Mon Jan 20, 2014 6:36 pm
by pieceseeker
Yea, you're probably right. I suppose even in some instances, the 500 extension table can be used as backup on the 520 on the other end.
Posted: Mon Jan 20, 2014 8:56 pm
by JPG
Depend upon your mind set, hoarder quotient, or neat freakiness to provide the answer.
Murphy says: Shortly after you dispose of something, you will wish you had it back!
Posted: Mon Jan 20, 2014 9:54 pm
by wa2crk
I usually want the stuff back as soon as I see the trash truck going down the street away from my house:D
Bill V
Posted: Wed Jan 22, 2014 10:55 pm
by benush26
wa2crk wrote:I usually want the stuff back as soon as I see the trash truck going down the street away from my house:D
Bill V
I had a similar problem...
Then I got divorced and that was the last time I had to worry about my stuff being thrown in the garbage!
