Page 1 of 1
Band Saw Dimentions/Footprint?
Posted: Wed Mar 12, 2014 8:57 pm
by tbirdtim
I am in the process of setting up my workshop. I am building a shelf above the shopsmith for all the accessories however I do not have a band saw yet but want to save room for it on the shelf. Can some one take a tape measure to theirs and let me know what the approximate space that I should save on my shelf.
Thanks
Posted: Wed Mar 12, 2014 10:31 pm
by teamtj
Mine measures:
12 inches wide
24 inches front to back
36 inches tall
Mine is an older band saw, so I don't know if the newer ones are the same or not...
Posted: Wed Mar 12, 2014 10:38 pm
by charlese
gotta add some height for the mounting tubes. I think with the table flat, it's a bit more than 24" Know that doesn't help but will measure tomorrow.
Makes a big difference if you mount it flat side front or side front.
How are you mounting them?
Posted: Wed Mar 12, 2014 10:47 pm
by 2centsworth
How are you mounting them to the shelf ? That will make a difference in height needed. Are you using the shopsmith accessories mounts ?
Posted: Thu Mar 13, 2014 12:09 pm
by danr
[ATTACH]24320[/ATTACH]
This is how I mounted my bandsaw on the shop built "Special Purpose Tool Storage Rack" from
Shopsmith plans.
Just drilled some holes in the top and let it lean against the wall. When I getaroundtoit, I'll make the mounting holes more stable.
Dan
Posted: Thu Mar 13, 2014 12:48 pm
by JPG
[ATTACH]24321[/ATTACH]
Please!!!!!!!!!
Posted: Thu Mar 13, 2014 3:30 pm
by tbirdtim
Thanks everyone. I have plenty of height. I am just planning to drill some holes in a 2x4 or 2x6 or two and mount that to a piece of 3/4 plywood as my shelf, that way I can move them around as I see fit. I will post pictures when it is done.
Posted: Thu Mar 13, 2014 8:47 pm
by danr
JPG40504 wrote:[ATTACH]24321[/ATTACH]
Please!!!!!!!!!
That is my homemade shavings collector for the jointer. Made it from one of vacuum attach nozzle and 1/4" hardboard.
Leaks a little because I could not form it to enclose the full opening but it works.
Have not drilled the holes to mount the jointer yet. Just need to getaroundtoit.
Dan
Posted: Thu Mar 13, 2014 9:02 pm
by charlese
With the table and rip fence attached, which is normal, the bandsaw is 33 1/2" wide and 35 inches deep. I also have the expansion table that when retracted adds 1/2". Take off the rip fence and it's only 33 inches deep.
Agree with 36 inches tall. Add about 2 inches for the part of the support tubes that don't go into the hole.