Page 1 of 1
Let's play "ID the ambiguous SS part"....please help.
Posted: Mon Sep 14, 2015 4:01 pm
by ibskot
[img]/img]I was going through a box I got from a guy when I got my belt sander and fond these. Have no clue. FWIW, he had been a real SS guy...but is not living anymore so I couldn't tap his brain. From the look of some of his stuff, he'd been a nice guy to know.
Item number 1. Has 2 set screw and fits on a 5/8 inch shaft.
Item number 2. Looks like there could have been some sort of retaining ring on one end.
Any help is appreciated.
Re: Let's play "ID the ambiguous SS part"....please help.
Posted: Mon Sep 14, 2015 4:13 pm
by wa2crk
#1 appears to be the lathe screw center without the screw. #2 I am not sure if is actually something for a Shopsmith. But on second thought it could be the stop plunger from a worktable trunnion but I would have to take a look at mine to tell for sure.
Bill V
Re: Let's play "ID the ambiguous SS part"....please help.
Posted: Mon Sep 14, 2015 4:48 pm
by ibskot
Thanks. Would I be able to get a new screw you think? Are they replaceable?
Re: Let's play "ID the ambiguous SS part"....please help.
Posted: Mon Sep 14, 2015 5:09 pm
by wa2crk
Screw should be a #12 about 1" long. Get one at any good hardware store.
Bill V
Re: Let's play "ID the ambiguous SS part"....please help.
Posted: Mon Sep 14, 2015 5:28 pm
by ibskot
Thanks a lot for your help.
Re: Let's play "ID the ambiguous SS part"....please help.
Posted: Mon Sep 14, 2015 5:44 pm
by wa2crk
Re: Let's play "ID the ambiguous SS part"....please help.
Posted: Mon Sep 14, 2015 5:54 pm
by ibskot
What are you? Rainman?
I am impressed and appreciative.
Re: Let's play "ID the ambiguous SS part"....please help.
Posted: Mon Sep 14, 2015 6:04 pm
by wa2crk
You are welcome !!
Bill V