Page 1 of 1
HELP: Bought a used SS
Posted: Tue Nov 30, 2010 7:59 pm
by brad_hb
SS Forum-
I just picked up a used SS with several attachments and parts. Not sure how to determine what model I have or how to put get started. The motor runs strong, I am not sure where to start. Appreciate any assistance...
Posted: Tue Nov 30, 2010 8:16 pm
by JPG
brad_hb wrote:SS Forum-
I just picked up a used SS with several attachments and parts. Not sure how to determine what model I have or how to put get started. The motor runs strong, I am not sure where to start. Appreciate any assistance...
Post some pix.
What color is it?
What does the vent plate say(on the 'left' end in the middle/shiney perforated).
Posted: Tue Nov 30, 2010 8:49 pm
by wa2crk
Brad;
WELCOME!!! As JPG said the more info we get from you the better we can answer your questions. However do not use the machine until you can completely check it out. Check the electrical cord for cuts bruises and possible deterioration of the insulation and make the ground pin is still on the plug.
Lots of good people here that will really help you. Don't be bashful and don't be afraid to ask questions. The only dumb question is the one that is not asked.
Bill V
Posted: Tue Nov 30, 2010 9:35 pm
by JPG
Here is a good place to start! Review the ones dealing with maintenance right away.
http://www.shopsmithacademy.com/Sawdust_Sessions.htm
Start with the ones describing 'restoring' a Mark 5(session 21,22,23) then those dealing with alignment and any dealing with an area you are experiencing problems with.
I encourage you to 'explore' the index etc.
Posted: Tue Nov 30, 2010 9:55 pm
by 8iowa
Another great source of information is "Power Tool Woodworking for Everyone". The latest 4th edition covers the Shopsmith 510 and all the tools that go with it. It can be purchased from Shopsmith (555069) or used copies are easy to obtain from internet book sources such as
http://www.abebooks.com