Shopsmith Forums

Thank you for all of the replies! I checked this again and was able to verify that when I run it having set the speed control at "M" (in the center of the Magna-Dado range) over the span of a minute or so, the speed creeps all the way to the "W". When the speed is set below the "M" the speed holds ...

I am a newbie on this forum and a new owner of an inherited MKV.

The other day while using the table saw I had the speed set at the low end of saw-joint. As the machine ran I could hear and observe the speed increasing. I resorted to bringing the speed down to the magna-dado speed range so that ...

I am not sure on that, but my friend who repaired and cleaned it recently, had the blank authorization to replace anything necessary.

I am a newbie on this forum and a new owner of an inherited MKV.

The other day while using the table saw I had the speed set at the low end of saw-joint. As the machine ran I could hear and observe the speed increasing. I resorted to bringing the speed down to the magna-dado speed range so that the ...