Search found 1172 matches
- Sat Feb 16, 2008 3:57 pm
- Forum: Woodworking Tool Review
- Topic: Shopsmith tools are too expenisve?
- Replies: 32
- Views: 50587
- Sat Feb 16, 2008 12:10 am
- Forum: Woodworking Tool Review
- Topic: Belt Sander question #2
- Replies: 10
- Views: 20811
- Sat Feb 16, 2008 12:02 am
- Forum: Woodworking Tool Review
- Topic: Shopsmith tools are too expenisve?
- Replies: 32
- Views: 50587
- Fri Feb 15, 2008 8:49 pm
- Forum: Beginning Woodworking
- Topic: Shopsmith bandsaw problem
- Replies: 30
- Views: 21938
- Fri Feb 15, 2008 8:47 pm
- Forum: Beginning Woodworking
- Topic: Shopsmith bandsaw problem
- Replies: 30
- Views: 21938
Thank! I was 100% sure it was the bearing in the lower wheel. I tried what you did and the noise stopped when I touched the lower guide bearing. Feeling better about this now. That bearing is a lot cheaper to fix than a new lower wheel. For years my Bandsaw has made a wailing sound almost errie that...
- Fri Feb 15, 2008 10:44 am
- Forum: Woodworking Tool Review
- Topic: Quill feed handle
- Replies: 10
- Views: 21138
- Thu Feb 14, 2008 8:36 pm
- Forum: Woodworking Tool Review
- Topic: Belt Sander question #2
- Replies: 10
- Views: 20811
- Thu Feb 14, 2008 4:20 pm
- Forum: Woodworking Tool Review
- Topic: Shopsmith tools are too expenisve?
- Replies: 32
- Views: 50587
Shopsmith tools are too expenisve?
I was looking at a Christmas 1989 catalog and noticed The Shopsmith belt sander is on sale now for the same price listed in the 1989 catalog. $319. I have to admit over the last 10 years I have kinda given up on Shopsmith because of the price of tools. But just recently started to take another look....
- Thu Feb 14, 2008 4:02 pm
- Forum: Woodworking Tool Review
- Topic: Belt Sander question #2
- Replies: 10
- Views: 20811
Belt Sander question #2
I have watched the video but have a question about the table position. The catalog says the table can be placed on the side of the belt. The only photo I see with the table on the side is with the use of the drum sander. Am I correct that the table can be used on the side with the belt? Is there a p...
- Tue Feb 12, 2008 9:48 pm
- Forum: Woodworking Tool Review
- Topic: Quill feed handle
- Replies: 10
- Views: 21138
Quill feed handle
Is the plastic end on the quill feed handle fixed of should it spin?