
Search found 4680 matches
- Thu Jan 21, 2021 6:12 pm
- Forum: Community
- Topic: Hello From Georgia USA
- Replies: 9
- Views: 208
Re: Hello From Georgia USA
Nervous Nellie's. 

- Wed Jan 20, 2021 4:56 pm
- Forum: Maintenance and Repair
- Topic: new to SS and 10E
- Replies: 10
- Views: 157
Re: new to SS and 10E
That's a speed changer, it's worth about $150.00 at the least. It's also a somewhat rare item. Don't over tighten it or it will break.
- Wed Jan 06, 2021 1:09 am
- Forum: General Woodworking
- Topic: rubber-bonded abrasive wheel
- Replies: 54
- Views: 51916
Re: rubber-bonded abrasive wheel
Because it's a soft wheel.
- Mon Jan 04, 2021 3:35 pm
- Forum: Community
- Topic: Stimulus Check
- Replies: 42
- Views: 2532
Re: Stimulus Check
Occupation:JPG wrote: ↑Mon Jan 04, 2021 2:19 pm1 "b" ???ChrisNeilan wrote: ↑Sun Jan 03, 2021 11:09 pm I’m employed full time (60 hours a week!) No check for me. As a tier 1b worker, I get my vaccine Friday! Grateful.
Funeral Director
- Mon Dec 28, 2020 2:14 pm
- Forum: Beginning Woodworking
- Topic: Just bought Shopsmith Mark V 520
- Replies: 9
- Views: 1274
Re: Just bought Shopsmith Mark V 520
First thing to do is clean it up, wax it, then align it. WD40 is okay to use, but clean the tubes with mineral spirits before waxing them.
- Fri Dec 18, 2020 6:24 pm
- Forum: Maintenance and Repair
- Topic: Instructions to shut Shopsmith on high-speed setting during speed control adjustment
- Replies: 16
- Views: 764
Re: Instructions to shut Shopsmith on high-speed setting during speed control adjustment
It's been said in the past that a medical grade GFCI creates less problems.
- Thu Dec 03, 2020 2:38 pm
- Forum: Community
- Topic: membership list
- Replies: 2
- Views: 428
Re: membership list
Bottom of the page of board index?
- Mon Nov 30, 2020 12:35 pm
- Forum: General Woodworking
- Topic: Not quite woodworking but still a shelf project....
- Replies: 3
- Views: 1173
Re: Not quite woodworking but still a shelf project....
Edited that line out.
- Mon Nov 23, 2020 1:17 pm
- Forum: Community
- Topic: Who Is Online
- Replies: 36
- Views: 1020
Re: Who Is Online
Don't call me a BOT. 

- Wed Nov 18, 2020 2:03 pm
- Forum: Beginning Woodworking
- Topic: New member here...
- Replies: 9
- Views: 1775
Re: New member here...
Clean it up, oil it, then align it and your ready to go.