Search found 34194 matches

by JPG
Thu Sep 28, 2023 9:50 am
Forum: Community
Topic: Oops, I did it again!
Replies: 4
Views: 64

Re: Oops, I did it again!

Ya done good!
by JPG
Wed Sep 27, 2023 8:51 am
Forum: General Woodworking
Topic: Hello everyone, I newbie
Replies: 2
Views: 124

Re: Hello everyone, I newbie

:D
by JPG
Tue Sep 26, 2023 7:04 pm
Forum: Community
Topic: Heads Up - Bargain 'available'
Replies: 2313
Views: 2206843

Re: Heads Up - Bargain 'available'

Key point is there is no negotiating nor bargaining done directly on the forum. That activity is ok in the Private Message option.

Exposing an item's availability invokes no liability to the forum sponsor(SS).
by JPG
Tue Sep 26, 2023 6:57 pm
Forum: Maintenance and Repair
Topic: Mark V double wide extension table
Replies: 4
Views: 203

Re: Mark V double wide extension table

Bottom mounting ?????
by JPG
Fri Sep 22, 2023 11:09 pm
Forum: Maintenance and Repair
Topic: The Ultimate Sawsmith Radial Arm Saw Thread
Replies: 179
Views: 185459

Re: The Ultimate Sawsmith Radial Arm Saw Thread

A Mark VII belt is wider than a Mark 5 belt.
by JPG
Fri Sep 22, 2023 11:08 pm
Forum: Community
Topic: looking for help pricing a Mark VII to sell
Replies: 26
Views: 748

Re: looking for help pricing a Mark VII to sell

By "tweak the switch", JPG meant take it apart and correct things.
by JPG
Fri Sep 22, 2023 9:46 am
Forum: Maintenance and Repair
Topic: The Ultimate Sawsmith Radial Arm Saw Thread
Replies: 179
Views: 185459

Re: The Ultimate Sawsmith Radial Arm Saw Thread

Is it possible it is the same as a M5 or a MVII?
by JPG
Thu Sep 21, 2023 9:22 pm
Forum: Community
Topic: Hello Shopsmith World
Replies: 23
Views: 2441

Re: Hello Shopsmith World

" the washers that go through the wood "

?????
by JPG
Thu Sep 21, 2023 11:04 am
Forum: Beginning Woodworking
Topic: What am I doing wrong?
Replies: 15
Views: 527

Re: What am I doing wrong?

Appears to me that the rod is intended to be aligned with the plastic spacer ring and bear against the outer side of the ring. That I assume makes the top of the lower guard near horizontal and parallel to the table bottom. I have never had my hands on one of these lower guards. So it seems to be a ...