Shopsmith Forums

The reason I initially asked was because I do not know how one can effectively do so.

Armature, segments? We be referring to induction motors. Windings are very low resistance, and it only takes one short to make the motor unusable.

i do not recall mentioning sand paper use with citrustrip.

How does one move a post to a different thread?

I surmise thy experience has been with an exceptionally competent moving company.

We all hope so as well!

AWWWWW I thought it was sado masochistic!

It ain't change that is troublesome for old farts, it is creating irrelevant, unnecessary, totally inappropriate, buzz word objective changes to replace references to concise terms

I hope "grinding dust" is a figure of speech! As for sandblasting the headstock, I would go the citrusstrip route. I would only remove flash from the seam.*sprue?" As for bearings, VXB is a decent source(not the best re the quill). Quit using a phone for a camera or ALWAYS take pix in...

I suggest thee stop chasing thy tail be comparing edges of different boards.

You need a known straight reference(straight edge or table surface) to critique each board edge.