Search found 33806 matches
- Sat Jan 28, 2023 3:06 am
- Forum: Community
- Topic: Hello from Michigan
- Replies: 1
- Views: 50
Re: Hello from Michigan
Magna American!
- Sat Jan 28, 2023 3:04 am
- Forum: Maintenance and Repair
- Topic: Mark VII a start and a long ways to go..
- Replies: 120
- Views: 5599
Re: Mark VII a start and a long ways to go..
wHY DO YOU THINK THE CAP IS BAD?
HAVE YOU VERIFIED THE START SWITCH IS MADE?
DOUBLE CHECK THE DIRECTION SWITCH CONTACTS ABS WIRING ARE CORRECT.
CAPACITORS RARELY GO BAD.
HAVE YOU VERIFIED THE START SWITCH IS MADE?
DOUBLE CHECK THE DIRECTION SWITCH CONTACTS ABS WIRING ARE CORRECT.
CAPACITORS RARELY GO BAD.
- Thu Jan 26, 2023 7:32 pm
- Forum: Maintenance and Repair
- Topic: Mark V Upper and Lower Blade Guard
- Replies: 2
- Views: 160
Re: Mark V Upper and Lower Blade Guard
MVII blade slot will prevent that.
- Wed Jan 25, 2023 6:00 pm
- Forum: Maintenance and Repair
- Topic: Slop in the Rails Adversly Effects Alignment
- Replies: 26
- Views: 756
Re: Slop in the Rails Adversly Effects Alignment
Manual biasing the table may create more repeatable results, but it contaminates the process.
- Mon Jan 23, 2023 11:19 pm
- Forum: Maintenance and Repair
- Topic: Table saw alignment fixture (Rockler)
- Replies: 31
- Views: 640
Re: Table saw alignment fixture (Rockler)
Let us establish some facts re the gauge. IIUC the pix with the gauge indicating about "57" with the small dial indicating a negative reading is the at rest, fully extended plunger. The "zero" pix is with the small dial indicating close to "1". The plunger is pushed in ...
- Mon Jan 23, 2023 9:57 am
- Forum: Beginning Woodworking
- Topic: Newbie, looking for a little info
- Replies: 15
- Views: 547
- Mon Jan 23, 2023 9:20 am
- Forum: Beginning Woodworking
- Topic: Newbie, looking for a little info
- Replies: 15
- Views: 547
Re: Newbie, looking for a little info
If you are primarily interested in turning, any of them will do. A model 10 with speed changer would top my list followed by a Mark 5(==Mark V 500) then a 505(510 less float tables etc. . . .
If considering a new purchase, consider the recently added stripped down version.
Avoid clones.
If considering a new purchase, consider the recently added stripped down version.
Avoid clones.
- Sun Jan 22, 2023 10:44 pm
- Forum: Maintenance and Repair
- Topic: Table saw alignment fixture (Rockler)
- Replies: 31
- Views: 640
- Sun Jan 22, 2023 7:24 pm
- Forum: Community
- Topic: Don't Know Why
- Replies: 14
- Views: 1103
Re: Don't Know Why
UMMV, but I NEVER experienced a DOS crash. Now thingies running under DOS, that is another universe.
If multi tasking, one had better have absolute memory management control!!!
If multi tasking, one had better have absolute memory management control!!!