Shopsmith Forums

Hmmmm!

1) how wide(height) is the blade(bottom edge to cutting edge)? 2) the gauge is used by having the blade in position above the index mark where there is more clearance. The blade height is correct IF when rotated towards the index mark, is touches the gauge at the index mark. 3) the gauge Will RISE I...

I think by letting it 'uncoil' itself, the possibility of becoming 'inside out' is possible.

Change password ?????

With a given length belt, the range of tracking will be similar on both pulleys. Without the high speed stop, the fully closed position of the pulleys(at opposite ends of the range) determines the limits. When the high speed stop is included the belt positioning is short of that fully closed motor p...

SYMMETRY exists. The sheave geometry is identical. IF the sheaves are allowed to traverse full range the belt/sheaves move in equal but opposite direction. However the introduction of the high speed stop creates an off set in the range of motion. So it is possible that the belt will ride higher on t...

The whiskey barrel stave is white oak.

I think I would stick with individual branch circuit GFCI protection. Less $$$ and more flexible.

1) Greenie is a term used for the first Mark 5 that superceded the Madel 10. Ditto the later goldie/brownie model.

2)I would. It also reduces rattling.

3)Whatever works for thee!!! A dark blue is what I recall from early 1950's.

The planer/jointer sharpening jig is intended to be used with the conical disc sander. It sorta can be used with a flat sanding disc.

I asked the question prematurely.