Search found 34764 matches
- Sat Jul 27, 2024 4:17 am
- Forum: Community
- Topic: Part needed for 10ER in Sydney
- Replies: 1
- Views: 37
- Fri Jul 26, 2024 11:30 pm
- Forum: Maintenance and Repair
- Topic: Too much corrosion?
- Replies: 3
- Views: 70
Re: Too much corrosion?
$40 would more reasonable.
That is some very severe corrosion and unless you are inclined to devote considerable time and effort to getting it usable, I would pass on it.
That is some very severe corrosion and unless you are inclined to devote considerable time and effort to getting it usable, I would pass on it.
- Fri Jul 26, 2024 10:58 pm
- Forum: Maintenance and Repair
- Topic: New Member starting Restoration
- Replies: 25
- Views: 784
Re: New Member starting Restoration
It has been suggested to use a metric 15 x 67 (IIRC) belt. It is very close to 9/16 x 26.5.
- Fri Jul 26, 2024 10:42 pm
- Forum: Maintenance and Repair
- Topic: Yet another "Goldie" Restoration
- Replies: 46
- Views: 8652
Re: Yet another "Goldie" Restoration
This has been mentioned before in other posts. IF you remove the cams from the shafts, mark them precisely so they go back on in the exact same position. The holes for the roll pins are not precision drilled. They all vary slightly. If you don't put the cams back in the same place the roll pins wil...
- Fri Jul 26, 2024 10:30 pm
- Forum: Maintenance and Repair
- Topic: Double Tilt Way Tubes.
- Replies: 7
- Views: 170
Re: Double Tilt Way Tubes.
Not sure if this the correct thread to post this, but here goes. The question of easily centering the original way tubes(52") when upgrading to the double tilt. AIUI the oem waytubes on an original double tilt SS is 52 5/8*". If so, then the 52" waytubes need to be off set from each e...
- Thu Jul 25, 2024 10:46 pm
- Forum: Maintenance and Repair
- Topic: Short Rails
- Replies: 14
- Views: 577
Re: Short Rails
I encountered an individual who used EMT for a model 10. He was satisfied with it.
Re: way tubes
"Maybe you simply did not understand where they were trying to lead you."
- Thu Jul 25, 2024 9:50 pm
- Forum: Maintenance and Repair
- Topic: Double Tilt Way Tubes.
- Replies: 7
- Views: 170
Re: Double Tilt Way Tubes.
It ain't about what HAS happened, but rather about preventing it happening.
- Thu Jul 25, 2024 1:51 pm
- Forum: Maintenance and Repair
- Topic: Double Tilt Way Tubes.
- Replies: 7
- Views: 170
Re: Double Tilt Way Tubes.
Thank You or providing the way tube length for double tilt.
So 5/16" is the correct width to plug 52" way tubes..
So 5/16" is the correct width to plug 52" way tubes..
- Thu Jul 25, 2024 1:47 pm
- Forum: Maintenance and Repair
- Topic: Short Rails
- Replies: 14
- Views: 577
Re: Short Rails
I would be inclined to use the 1 1/2" EMT for BENCH tubes. They are always under tension.