While it may not wear as well, I DID check that it would go all the way out to the edge (well, 1/8 inch from it) of the pulleys without slipping between the fingers at the center of the other pulley.
It seems to be working just fine.
Search found 57 matches
- Mon Aug 09, 2010 10:06 am
- Forum: Maintenance and Repair
- Topic: A true replacement belt
- Replies: 12
- Views: 7722
- Sun Aug 08, 2010 6:51 pm
- Forum: Maintenance and Repair
- Topic: A true replacement belt
- Replies: 12
- Views: 7722
A true replacement belt
OK, I searched the forums, and I found some suggestions... But here's a hot tip. You can get a replacement drive belt at Ace Hardware. It's made by Mitsubishi, it costs less than $8, and the number is 4L260. I'll post a photo of the sleeve shortly. It's 1/2 inch by 26 inches. I've installed one on m...
- Sun Aug 08, 2010 6:47 pm
- Forum: Maintenance and Repair
- Topic: Finish on steel tables
- Replies: 15
- Views: 7151
- Sun Aug 08, 2010 1:19 pm
- Forum: Beginning Woodworking
- Topic: Using 7 1/4" Table Saw Blade - appropriate?
- Replies: 59
- Views: 27498
- Sun Aug 08, 2010 1:18 pm
- Forum: Maintenance and Repair
- Topic: Finish on steel tables
- Replies: 15
- Views: 7151
- Sun Aug 08, 2010 9:15 am
- Forum: Maintenance and Repair
- Topic: Jointer rebuild questions.
- Replies: 23
- Views: 12745
It took me almost 2 hrs adjusting the knives using the straight edge. I tried it the next time with a dial indicator, using the .001 - .003 heighth mentioned in the manual. It took me less than 30 minutes. I had just the opposite experience. Bought a dial indicator, set it up, but just couldn't get...
- Sun Aug 08, 2010 9:09 am
- Forum: Maintenance and Repair
- Topic: Finish on steel tables
- Replies: 15
- Views: 7151
Finish on steel tables
What is the "finish" on the surfaces of the steel bandsaw table and the jointer? The ones I got from my father-in-law are rusted, and removing the rust removes the finish, too. Some sort of "black oxide" finish, maybe?
- Thu Aug 05, 2010 4:22 pm
- Forum: Maintenance and Repair
- Topic: Questions: About Reconditioning a Mark V
- Replies: 22
- Views: 7627
- Wed Aug 04, 2010 2:47 pm
- Forum: General Woodworking
- Topic: A Very Satisfying Book-Match
- Replies: 9
- Views: 2820
- Mon Aug 02, 2010 6:43 pm
- Forum: Maintenance and Repair
- Topic: Jointer blades
- Replies: 5
- Views: 3900