Thanks Bill, but the shaft is already slightly rounded as is the bearing (in the
wheel) where it meets the shaft. It's just so darned tight that I can't even
muscle it on not to mention the wheel probably weighs 30-40 pounds. So it's
difficult to hold in alignment with the shaft so that I can ...
Search found 2 matches
- Thu Jul 22, 2010 2:10 am
- Forum: Maintenance and Repair
- Topic: Wheel Install Blues
- Replies: 3
- Views: 2428
- Wed Jul 21, 2010 11:46 pm
- Forum: Maintenance and Repair
- Topic: Wheel Install Blues
- Replies: 3
- Views: 2428
Wheel Install Blues
Hello all,
Have a General 90-270, 18" saw. Had to replace the bottom tire. Used a gear
puller to get the wheel off and it was stubborn all the way till the very end of
the sppindle. After soaking the tire in hot water and with the assistance of a
couple of heftey c-clamps and heavy ...
Have a General 90-270, 18" saw. Had to replace the bottom tire. Used a gear
puller to get the wheel off and it was stubborn all the way till the very end of
the sppindle. After soaking the tire in hot water and with the assistance of a
couple of heftey c-clamps and heavy ...