Shopsmith Forums

Sorry if I mess up posting this. I am the other blade wobble person. My problem was fixed by replacing the arbor. shopsmith engineer was kind enough contact me and trust my measurements which he said was out of spec. He sent me a new arbor that I measured maybe 1 mil at the arbor and maybe 0 to 4 m ...

I’m the new guy in case it isn’t obvious. I will try to get a video of the wobble if someone can tell me how to post it.

Yes on kickback and burning with new blade and arbor

I have been using a cheap dial gauge. I use it for the fence every time and blade and table sometimes. I get very consistent results and measurements the bare arbor around .002 out.

I think using the Bosch would be a quick way to verify the calibration. Assuming that the initial calibration is as accurate as possible. I am a beginner woodworker and have just ordered a Mark 7. I am looking forward to getting the alignment as accurate as possible. After that I will post if the Bo...