Thanks so much, JPG40504!!! Extremely helpful and appreciated!JPG40504 wrote:I would just snug them. The inner race must not be bound, but the outer race can be tight against the spacer.
Search found 2 matches
- Thu Aug 07, 2014 8:20 am
- Forum: Woodworking Tool Review
- Topic: Proper Use of Bearing Press ?
- Replies: 8
- Views: 4770
- Wed Aug 06, 2014 10:48 pm
- Forum: Woodworking Tool Review
- Topic: Proper Use of Bearing Press ?
- Replies: 8
- Views: 4770
Drive bearings
Hey all! I'm getting ready to put drive bearings on my 10e and had a question: When I'm pressing the new bearings on, there's a spacer between the two, does the spacer need to be really tight against the bearings or leave it so it can move a bit freely on its own? Any advice would be GREATLY ...