Shopsmith Forums

How did the finish on the bar look? Did you use any lubricant?

Thanks for the reply. As far as cutting aluminum, you can use any carbide cutting tool with an edge. Just make sure you have it secured in a holder good.

Thanks for the reply. I'm going to check that out.

This is my first time ever to post in any forum so I'm not sure if I'm in the right place or going about this the right way so forgive me. I will make this a simple as possible. I would like to put a 3 Jaw chuck on my Mark V to turn aluminum round stock up to 3". I was wondering where to find one ...