Search found 5 matches

by MilRet
Mon Jan 23, 2023 9:16 pm
Forum: Maintenance and Repair
Topic: Table saw alignment fixture (Rockler)
Replies: 31
Views: 3204

Re: Table saw alignment fixture (Rockler)

I read your two visuals as .000" and .682". As I said just before this post, I look for something less than .005". Since the OP is learning the indicator, I have to disagree here. 0.682" is a huge number in this context. I read the two visuals as about 0.100" and about 0.06...
by MilRet
Wed May 20, 2020 8:51 pm
Forum: Maintenance and Repair
Topic: Indicator Ring does not move
Replies: 5
Views: 5126

Re: Indicator Ring does not move

Thank you very much for the fast response and help.

I am once again a Happy camper!
by MilRet
Wed May 20, 2020 8:45 pm
Forum: Maintenance and Repair
Topic: Indicator Ring does not move
Replies: 5
Views: 5126

Re: Indicator Ring does not move

I finally removed the control dial after finding correct tool!

Found the small sprocket off the larger one.

The nut holding it was loose. I held the slotted screw while tightening the nut.

Is the nut supposed to be loose?
by MilRet
Wed May 20, 2020 7:48 pm
Forum: Maintenance and Repair
Topic: Indicator Ring does not move
Replies: 5
Views: 5126

Re: Indicator Ring does not move

The Speed Control Dial (indicator ring) has teeth (see upper arrow in the picture below) under the Speed Control Handle which is turned by the gear mounted on the front of the Control Bracket (see lower arrow in the picture below). That gear is turned by the teeth on the inside center of the Speed ...
by MilRet
Wed May 20, 2020 6:34 pm
Forum: Maintenance and Repair
Topic: Indicator Ring does not move
Replies: 5
Views: 5126

Indicator Ring does not move

I have a mark V (2000). The issue I have: the speed dial works for increasing/ decreasing the speed but the indicator ring does not move. I called Shopsmith today to ask what part I need as I wanted the 20% off sale but was told to email catreq@shopsmith.com instead. I have not heard back so I was h...