Search found 7 matches
- Thu Jun 08, 2023 4:04 pm
- Forum: Maintenance and Repair
- Topic: How to Resolve a RPS State Error 0
- Replies: 51
- Views: 95470
Re: How to Resolve a RPS State Error 0
This is a pretty old thread. I just got this error after 15 years+ with the Powerpro on a Mark V. I was intimidated, but the tube video showing the unit with the cover off was enough. I took off the cover, vacuumed the dust and Used pressurized air to blow into the area where the speed sensor is. Th...
- Sat Feb 15, 2020 10:29 am
- Forum: Maintenance and Repair
- Topic: PowerPro High Inverter Heat Issue
- Replies: 60
- Views: 61753
Re: PowerPro High Inverter Heat Issue
Got a high heat message while pushing my bandsaw to the limit in a cold (<60deg) garage are all the posts on this forum more than 5 years old? Is anyone out there?
- Thu May 03, 2018 2:49 pm
- Forum: Maintenance and Repair
- Topic: SAFETY HAZARD on Powerpro upgrade
- Replies: 20
- Views: 17448
Re: SAFETY HAZARD on Powerpro upgrade
After a month, still no controller. I have been promised a call back 5 different times with no result. Calling daily now. Who owns Shopsmith now?
- Wed Apr 25, 2018 7:17 pm
- Forum: Maintenance and Repair
- Topic: SAFETY HAZARD on Powerpro upgrade
- Replies: 20
- Views: 17448
Re: SAFETY HAZARD on Powerpro upgrade
I have been told that my powerpro controller works fine. They said they are sending it back. That was over a week ago. They suggested that I take a video the next time that the machine won’t stop. Perhaps I can get a video of it chopping off my fingers.
- Fri Apr 06, 2018 12:39 pm
- Forum: Maintenance and Repair
- Topic: SAFETY HAZARD on Powerpro upgrade
- Replies: 20
- Views: 17448
Re: SAFETY HAZARD on Powerpro upgrade
It is now 3 weeks since I tried contacting Shopsmith. I have sent 5 emails and left 2 voice mails. I called last week and the person said I likely talked to a new girl and nothing was done. I just called and got through quickly (a first), Unfortunately there was no record of my problem. They said th...
- Sat Mar 24, 2018 8:30 am
- Forum: Maintenance and Repair
- Topic: SAFETY HAZARD on Powerpro upgrade
- Replies: 20
- Views: 17448
Re: SAFETY HAZARD on Powerpro upgrade
That’s easier said than done. After a week of waiting on hold, leaving voicemails and sending emails, I got a live person at 4:25 on a Friday afternoon. Hopefully an engineer will call back to get this resolved.
- Mon Mar 19, 2018 7:01 pm
- Forum: Maintenance and Repair
- Topic: SAFETY HAZARD on Powerpro upgrade
- Replies: 20
- Views: 17448
SAFETY HAZARD on Powerpro upgrade
Please help. I upgraded my 1960 era Mark 5 a few years ago. Made a tremendous difference and was worth the cost. However yesterday while I was using the lathe, I couldn’t stop the motor. I had to throw the main switch to get the motor to stop. Pushing the stop button jest made the screen go blank. I...