Search found 10 matches
- Thu Sep 03, 2020 1:30 am
- Forum: Maintenance and Repair
- Topic: Adjusting Belt Tension
- Replies: 18
- Views: 14184
Re: Adjusting Belt Tension
And not sure why pics are sideways... Done from iphone
- Thu Sep 03, 2020 1:21 am
- Forum: Maintenance and Repair
- Topic: Adjusting Belt Tension
- Replies: 18
- Views: 14184
Re: Adjusting Belt Tension
The 610 refreshed as well
- Thu Sep 03, 2020 1:18 am
- Forum: Maintenance and Repair
- Topic: Adjusting Belt Tension
- Replies: 18
- Views: 14184
Re: Adjusting Belt Tension
Should have written gilmer but it autocorrect
- Thu Sep 03, 2020 1:17 am
- Forum: Maintenance and Repair
- Topic: Adjusting Belt Tension
- Replies: 18
- Views: 14184
Re: Adjusting Belt Tension
I just restored/rejuvenated my greenie tried some cuts and noticed a slow down in motor speed along with belt slippage smell... checked both belts... the filmed was fine but poly belt seems to be chewed up.. what would cause this as gilmer is tensioned to 1/8 to 1/4 deflection.
- Wed Sep 02, 2020 12:12 pm
- Forum: Beginning Woodworking
- Topic: Introduction
- Replies: 27
- Views: 13640
Re: Introduction
Tks... Was afraid wouldnt be easy ⚙
- Wed Sep 02, 2020 1:17 am
- Forum: Beginning Woodworking
- Topic: Introduction
- Replies: 27
- Views: 13640
Re: Introduction
Ball not stuck and yes need to replace the gasket
- Tue Sep 01, 2020 8:01 pm
- Forum: Maintenance and Repair
- Topic: Jigsaw 610 Restore Parts
- Replies: 44
- Views: 14993
Re: Jigsaw 610 Air Pump
Has anyone figured out how to replace the gasket on two halves... mines leaking.
- Tue Sep 01, 2020 6:07 pm
- Forum: Beginning Woodworking
- Topic: Introduction
- Replies: 27
- Views: 13640
Re: Introduction
The other view
- Tue Sep 01, 2020 6:05 pm
- Forum: Beginning Woodworking
- Topic: Introduction
- Replies: 27
- Views: 13640
Re: Introduction
Had a problem with both but got the front to back one figured out but I have a left to right( looking at cutting edge of blade) of about 1/16 of an inch movement... not sure if that is a lot. When I tried a practice cut follows the line I drew ok but notice the blow for removing saw dust from the tu...
- Tue Sep 01, 2020 11:01 am
- Forum: Beginning Woodworking
- Topic: Introduction
- Replies: 27
- Views: 13640
Re: Introduction
I have the 610 manual but my question is what is the blade angle from the top and bottom. Mr looks like there is an inches or two variation which seems off. The maneal doesnt give info on this. Any help appreciated.