Ahhhh, thanks so much! I could not figure out what was wrong. I thought initially, perhaps the main casting should be flipped, but the way I had it seemed to match the manuals. I would have never got that. Now I know what a trunion is!
Joe
Search found 7 matches
- Thu Jul 09, 2020 10:44 pm
- Forum: Maintenance and Repair
- Topic: 10ER Table Alignment issue as drill press
- Replies: 4
- Views: 3002
- Thu Jul 09, 2020 5:52 pm
- Forum: Maintenance and Repair
- Topic: 10ER Table Alignment issue as drill press
- Replies: 4
- Views: 3002
10ER Table Alignment issue as drill press
I have just been getting my Shopsmith 10ER working and I set it up as a drill press. Checking the perpendicularity of the drill shaft to the table is not good. Hopefully the 1st picture will show the problem. $matches[2] The set square shows the mis-alignment to the drill bit and the blue arrow show...
- Thu Jul 09, 2020 5:11 pm
- Forum: Maintenance and Repair
- Topic: Trouble Attaching to Spindle of 10ER
- Replies: 11
- Views: 7329
Re: Trouble Attaching to Spindle of 10ER
Here are some additional pictures and some gifs grabbed from the modifications document stored on Google Docs.
I have; the machined rails on the tail stock, the groove on the quill housing, and the hole behind the serial number place.
I have; the machined rails on the tail stock, the groove on the quill housing, and the hole behind the serial number place.
- Wed Jul 08, 2020 6:25 pm
- Forum: Maintenance and Repair
- Topic: Trouble Attaching to Spindle of 10ER
- Replies: 11
- Views: 7329
Re: Trouble Attaching to Spindle of 10ER
For the serial number. We removed the shopsmith plate when we painted the body. During removal, the drill slipped and damaged a bit of the plate. There could be a digit before the 9717 but I cannot tell what it would be. I went out with a pretty powerful magnifying glass and the spot where the numbe...
- Wed Jul 08, 2020 3:37 pm
- Forum: Maintenance and Repair
- Topic: Trouble Attaching to Spindle of 10ER
- Replies: 11
- Views: 7329
Re: Trouble Attaching to Spindle of 10ER
So I removed the spindle and front collar,. The front bearing was not pushed down enough. Correcting that fixed the issue Ron and John identified. When I loosened the front collar, I noticed I could not completely take the collar off the spindle. It would get stuck right at the end of the spindle sh...
- Tue Jul 07, 2020 6:17 pm
- Forum: Maintenance and Repair
- Topic: Trouble Attaching to Spindle of 10ER
- Replies: 11
- Views: 7329
Re: Trouble Attaching to Spindle of 10ER
Thanks for the reply. Here are some pictures.
- Tue Jul 07, 2020 4:38 pm
- Forum: Maintenance and Repair
- Topic: Trouble Attaching to Spindle of 10ER
- Replies: 11
- Views: 7329
Trouble Attaching to Spindle of 10ER
Hello; I hope I am posting this to the proper forum. I have been restoring my grandfathers Shopsmith 10ER (Serial #9717). I had to purchase a new chuck from Shopsmith as that item was missing (item# 505633, Shopsmith Drill Chuck and Key). The issue I am having is getting the chuck on to the spindle ...