Shopsmith Forums

Thanks the more sites to search the better

That might be the better choise for me too After more disassembling It's not looking good Apparently the cam I had was an extra heres what I found inside Power supply wires are rock hard and some are bare The sheave looks ok but the end where the bearing fits into has a piece missing Looks like the ...

Ok I'll keep looking for a replacement and maybe I can find one by the time I get everything checked,cleaned and painted
What would the good price be on this cam if I can find one ?

Took a few more pics after I cleaned the dirt off
Nothing is cracked but I can see where it is worn some what flat in one area
and a small piece is gone from the edge

Yes base doesn't appear to be to bad but will need to paint also
A few more pics of cam too

Just to try with the drive belt off the motor goes in forward and reverse.Didn't let it run but a few seconds,it does have an old Part # Poly V-Belt
A few pics of Rusty Smith[ATTACH]13539[/ATTACH]

[ATTACH]13540[/ATTACH]

[ATTACH]13541[/ATTACH]

[ATTACH]13542[/ATTACH]

[ATTACH]13543[/ATTACH]

Yes that was the one I bought
Has a 4" Magna jointer,chisels about 5 saw blades and a dozen or so fittings
Should be interesting

Thanks Damagi
Yes will need cam for sure not sure about anything else yet
Will start to dismantle,clean and check after the manual comes in
a week or so

Hi ya'll new to shop smith and this site Live in Oklahoma , 50 ish havent done any woodworking since school over 43 years now. Have been welding for the past 37 years... man I'm feeling older as I type ! Currently welding aircraft parts...Will have many questions but i'll search the forum first to f...