Received the new chuck yesterday, works great with no perceivable wobble!
Thanks everyone.
Search found 5 matches
- Mon Sep 07, 2020 10:54 am
- Forum: Maintenance and Repair
- Topic: 10ER chuck wobble
- Replies: 11
- Views: 3244
- Tue Sep 01, 2020 7:45 pm
- Forum: Maintenance and Repair
- Topic: 10ER chuck wobble
- Replies: 11
- Views: 3244
Re: 10ER chuck wobble
Yes. 0.61 inch. I assume that is unusual. ID plate for reference.
Very! 0.015 too small. May be the source of wobble.
How/where in the shaft did you measure it and with what.
As far as I can tell visually, the shaft is true. I measured it over the exposed length. No taper from what I can tell ...
Very! 0.015 too small. May be the source of wobble.
How/where in the shaft did you measure it and with what.
As far as I can tell visually, the shaft is true. I measured it over the exposed length. No taper from what I can tell ...
- Tue Sep 01, 2020 1:16 pm
- Forum: Maintenance and Repair
- Topic: 10ER chuck wobble
- Replies: 11
- Views: 3244
Re: 10ER chuck wobble
Yes. 0.61 inch. I assume that is unusual. ID plate for reference.
- Tue Sep 01, 2020 10:41 am
- Forum: Maintenance and Repair
- Topic: 10ER chuck wobble
- Replies: 11
- Views: 3244
Re: 10ER chuck wobble
Interesting post, thanks.
I will try one of those newer chucks and see how it fits.
I will try one of those newer chucks and see how it fits.
- Mon Aug 31, 2020 11:47 pm
- Forum: Maintenance and Repair
- Topic: 10ER chuck wobble
- Replies: 11
- Views: 3244
10ER chuck wobble
I have a 10ER that I'd like to know a little more about the standard chuck setup. I'm not sure the one on it is quite right and it currently has about a 1/8" wobble at the end of a drill bit on the No 14 chuck. The shaft on mine measures 0.61", which a sleeve attached to the chuck goes on. From what ...