The machine ok, however, every so often the display goes blank. PP still runs ok, but blank display. Turning the machine off then on again solves the problem, until it happens again.
Any ideas?
Search found 2 matches
- Mon Oct 07, 2024 8:18 pm
- Forum: Maintenance and Repair
- Topic: Power pro display
- Replies: 2
- Views: 786
- Sun Jan 17, 2021 11:29 pm
- Forum: Maintenance and Repair
- Topic: How to Resolve a RPS State Error 0
- Replies: 51
- Views: 101077
Re: How to Resolve a RPS State Error 0
Take the belt guard and pan off, put the machine in drill press position, remove the 4 lower motor screws, (loosen the top 2 screws, but don't remove them). Tilt the motor out which exposes the screws holding the black plastic shroud, remove the shroud, (3 screws). Use a can of compressed air to blo...