Shopsmith Forums

RE: Renaissance Wax

6 or 7 years from now when you use it all the time and you still have half a jar, you'll forget how much it cost.

Renaissance Wax. For both.

That's exactly the issue. If I stop frequently and poke around on the filter bag I can knock the shavings down into the bag. But, as soon as I turn it on, you can see the turbulence pushing them back up into the filter bag, where they pack up on top of the motor housing and the impellor. I may play ...

I think I have the owner's manual. I'll see if I can track down a date. Having lived with both of them for a couple years, I don't consider the change an "upgrade". I'm a little surprised at the lack of recognition. First design must have only lasted a couple years.

As promised, some pics of my two DC-3300s https://lh3.googleusercontent.com/pw/AJFCJaUfUNapwp72JZccCjpln1xEyUuA95Et6DljZy7TmMTOXuzl0EmX3PJQTaBaflzHimeZauNCvy0HNFqM78P7VHI5CHrZuD3jxDRWeZYXi1uG-cY6LuJVL9NhFQgkaa9-ff8PCDvUUPhvcPfVUOBQ9QZk=w887-h665-s-no?authuser=0 Older DC-3300 with motor only partiall...

I actually have two DC-3300s, one of the early, steel housing units (3300) and one of the plastic housing units (3300-2). The 3300-2 has the optional 4" inlet. I'll add some pictures of them side-by-side tonight. I like the 3300 for what it is, but we all have to accept what it isn't. It is not...

I have a 3300 with the factory 4" inlet and the middle-sized (24") filter. I'm using it with an INCA 10" combination jointer/planer. The fluffy planer shavings end up packing up on top of the impeller body in the filter bag, instead of down in the plastic bag. This happens no matter h...

I was recently in the market for a used DC-3300. On inspecting the first one that I found, I turned it on and dust started blowing out the motor vent area. I pulled the filter bag off and scratched my head at the design, as the seals were completely disintegrated and non-existent. I passed. On doing...

There are no detents to locate the angle of the mortise. In the owner's manual we show the procedure to use a square against the key that turns the template.

I'll share this with the product engineer tomorrow and report back. Other than possibly being just a little too thick, I think it is going to work.