Shopsmith Forums

that nice, the poly only was a good choice, looks very good

Yes, pens can be done on a Shopsmith. And other small things also. If you buy a chuck you will have to get a SS adaptor for the chuck.DSC00912.JPGtrifecta.JPG Bill V Bill: some very nice work sir, i hope with alot of practice i can do close to that quality has anyone used or own the SS Nova penset ...

just wanted to say thank you to everyone, it really wasnt a major deal. the table, quill and everything else is checking fine, was more of a observation but i did go over the links and suggestion and i do appreciate eveyones time.

thats real nice work,

the tubes in the upright are just shy of 90 about 1/2 a bubble and the same on the other end in the upright, but in the horizontal she is dead true, and the table to quill is true, every other item i have checked so far has been close as possible.

Troy, This is a looong thread linked below, but it discusses what you are asking, I believe. By the way, there was A LOT of confusion on this thread until everyone understood what was being discussed. Hope this helps. https://forum.shopsmith.com/viewtopic.php?p=287868#p287868 By the way, you can re...

i have been going slow with the new "used mk 7" haven't had alot of free time. i started off checking alignment and discovered that several of the leg bolts, lift assist bolts and caster bolts were not real tight, so i backed off went to step one off install and setup, everything is fallin...

looks fantastic, id be proud of that

looks good,

Has anyone done one of mr reids or the ShopSmith webinars ? and approximately how long do they last, how much bandwidth is needed? and is a mic & Cam needed ??

we are out in the rural and my internet drifts between 5 meg and 11 meg down "a real good day".

thanks