Search found 744 matches
- Mon Nov 06, 2023 5:10 pm
- Forum: General Woodworking
- Topic: DIY Christmas trees
- Replies: 22
- Views: 41660
Re: DIY Christmas trees
Still inspecting
- Mon Nov 06, 2023 10:58 am
- Forum: General Woodworking
- Topic: DIY Christmas trees
- Replies: 22
- Views: 41660
Re: DIY Christmas trees
Here are two prototypes ready for final sandings and paint I’ll post final when done
- Sat Nov 04, 2023 1:18 pm
- Forum: General Woodworking
- Topic: DIY Christmas trees
- Replies: 22
- Views: 41660
Re: DIY Christmas trees
I should mention I floated all suggestions pass the Commander and Chief and this what she thinks she wants. I mention thinks since the last project I made for her had NUMEROUS prototypes ending up it the recycle bin. Thanks for all the suggestions.
- Sat Nov 04, 2023 1:05 pm
- Forum: General Woodworking
- Topic: DIY Christmas trees
- Replies: 22
- Views: 41660
Re: DIY Christmas trees
If it is I will post a final photo if not back to the drawing board. We (she) decided the tapering way is how we (she) wants it.
- Fri Nov 03, 2023 11:59 pm
- Forum: General Woodworking
- Topic: DIY Christmas trees
- Replies: 22
- Views: 41660
Re: DIY Christmas trees
OK this was what I started with but she would like it on both sides but with the bottom having more layers than the top on both side but still have the overlap. Sorry best I can try to explain.
- Fri Nov 03, 2023 11:54 pm
- Forum: General Woodworking
- Topic: DIY Christmas trees
- Replies: 22
- Views: 41660
Re: DIY Christmas trees
IMG_9324.jpeg Hard for me to explain but I’ll try imagine a flat two sided Christmas tree say made with 1/4” plywood then on front and back surface the bottom having a decorative piece adding about 1/4 inch on front and back bottom then the middle with a little thinner piece doing the same thing th...
- Thu Nov 02, 2023 11:05 pm
- Forum: General Woodworking
- Topic: DIY Christmas trees
- Replies: 22
- Views: 41660
DIY Christmas trees
My better half would like me to make some 8” to 10” Christmas trees for her seasonal decorations. She wants them to look kind of 3dish but only be two sided with the bottom being thicker than the top but not on a slant. I’ve given her a couple ideas but she does not care for them. Has anybody made a...
- Tue Jun 06, 2023 12:24 pm
- Forum: General Woodworking
- Topic: Small staple removal
- Replies: 3
- Views: 2322
Re: Small staple removal
Just a thought. If necessary a thin scrap could be placed under vice grips to assure no damage.
- Sun May 07, 2023 9:34 pm
- Forum: Maintenance and Repair
- Topic: Wheel replacement
- Replies: 12
- Views: 1401
Re: Wheel replacement
1 3/4 inches between new hole and prior hole from smaller casters.
- Tue May 02, 2023 10:19 am
- Forum: Maintenance and Repair
- Topic: Wheel replacement
- Replies: 12
- Views: 1401
Re: Wheel replacement
Thank all of you. I started out with a block under the end and when trying to pry the wheel off it came off with the housing. Tried to get housing back in was was having too much trouble. Removed wheel assembly and after some difficulty getting housing back in I put new wheel in and housing back. I ...