The results of lack of advertising. Out of sight, out of mind.
Wonder WHO came up with the new corporate slogan!
Search found 34643 matches
- Tue Mar 12, 2024 11:51 am
- Forum: Community
- Topic: Shopsmith at Workbench Con 2024
- Replies: 10
- Views: 667
- Tue Mar 12, 2024 11:44 am
- Forum: Maintenance and Repair
- Topic: Mark 5 doesn’t start
- Replies: 10
- Views: 451
Re: Mark 5 doesn’t start
IF it IS as you described, it is indeed more than 30 yrs old(Think 1950ish). Also it is likely green and silver colored. Does the quill shaft rotate by hand(It will have belt resistance depending upon where the speed control is set) If it rotates so slowly that you can count the revolutions, it is N...
- Tue Mar 12, 2024 12:00 am
- Forum: Maintenance and Repair
- Topic: Dragged out a shopsmith
- Replies: 32
- Views: 1381
Re: Dragged out a shopsmith
I would be cautious about recommending paste floor wax. Many now have abrasives added for a non-slip finish, and this is not what you want to use on your Shopsmith. Which is why "Original Johnson Paste Floor Wax has been the staple in the past Min wax is a finishing wax and does not contailn &...
- Sat Mar 09, 2024 4:38 pm
- Forum: Community
- Topic: Email Notifications
- Replies: 9
- Views: 370
Re: Email Notifications
I get too many e-mail as it is!
- Sat Mar 09, 2024 2:58 pm
- Forum: Maintenance and Repair
- Topic: Greenie Parts replacement help
- Replies: 5
- Views: 330
Re: Greenie Parts replacement help
The part is essentially a dust cap only. As for noise reduction, a thick layer of grease accomplishes that. That grease is the reason for a dust cap.
Yes I think one could be 3d printed. David provided the necessary design goals.
Yes I think one could be 3d printed. David provided the necessary design goals.
- Sat Mar 09, 2024 9:36 am
- Forum: Maintenance and Repair
- Topic: Dragged out a shopsmith
- Replies: 32
- Views: 1381
Re: Dragged out a shopsmith
Ah So!
- Fri Mar 08, 2024 10:25 pm
- Forum: Maintenance and Repair
- Topic: Dragged out a shopsmith
- Replies: 32
- Views: 1381
Re: Dragged out a shopsmith
Whatsa "squirrel cone"?
- Fri Mar 08, 2024 5:36 pm
- Forum: Maintenance and Repair
- Topic: Dragged out a shopsmith
- Replies: 32
- Views: 1381
Re: Dragged out a shopsmith
You done good!
- Fri Mar 08, 2024 5:34 pm
- Forum: General Woodworking
- Topic: Stair railing
- Replies: 16
- Views: 1773
Re: Stair railing
Then the spammer willl disappear.(maybe the thread also)
- Fri Mar 08, 2024 3:16 pm
- Forum: General Woodworking
- Topic: Stair railing
- Replies: 16
- Views: 1773