Search found 182 matches
- Fri Aug 09, 2019 10:00 am
- Forum: Community
- Topic: Birthday Congratulations
- Replies: 3
- Views: 11012
Re: Birthday Congratulations
Shopsmith has a birthday list of its members?
- Thu Aug 01, 2019 4:08 pm
- Forum: Maintenance and Repair
- Topic: Maintenance and lubing
- Replies: 12
- Views: 31341
Re: Maintenance and lubing
I remember reading in an older post, I believe it was Bill Mayo, mentioned that some of the early sheaves didn't have oil holes.
- Sat Jul 27, 2019 10:54 am
- Forum: Maintenance and Repair
- Topic: Dado Blade Instructions
- Replies: 15
- Views: 30017
Re: Dado Blade Instructions
Here's a photo of how mine is configured. It may be wrong but does a great job. I was always told to never stack them together with the same tooth pattern side by side so my cutters are lined up with the rakers.
- Sat Jul 27, 2019 7:01 am
- Forum: Maintenance and Repair
- Topic: Dado Blade Instructions
- Replies: 15
- Views: 30017
Re: Dado Blade Instructions
If they mentioned tooth breakage they were probably talking about dados with carbide cutters. The Shopsmith dado set would be very difficult to break a tooth on. If you look at the photo of Brenda's Freud dado set carbide cutters you can see why slippage could cause breakage.
- Thu Jul 25, 2019 6:04 pm
- Forum: Maintenance and Repair
- Topic: Dado Blade Instructions
- Replies: 15
- Views: 30017
Re: Dado Blade Instructions
True but every other tooth is set in the opposite direction. If you start your cut with I, the next cut will be III. I don't think it makes that big a difference with a thinner cut using only the two outside blades as long as the blades are installed in the proper direction.
- Sun Jul 21, 2019 7:22 am
- Forum: Community
- Topic: Never to Old to Learn
- Replies: 15
- Views: 34773
Re: Never to Old to Learn
One thing that is unfortunate on almost all Shopsmith products and probably a lot of other manufacturers as well is the on/off switch is not in plain site or in a convenient location. Without the main table installed it is much easier, but that is not often. Alternate methods of shutoffs, especially...
- Sat Jul 20, 2019 5:56 am
- Forum: Maintenance and Repair
- Topic: Parts for gilmer clutch?
- Replies: 6
- Views: 14520
Re: Parts for gilmer clutch?
I just re-read that entire thread. A lot of good info in there from some great minds.
- Thu Jul 18, 2019 5:54 pm
- Forum: Maintenance and Repair
- Topic: Parts for gilmer clutch?
- Replies: 6
- Views: 14520
Re: Parts for gilmer clutch?
There is a thread on here somewhere where someone was able to successfully put one back together to achieve the proper torque by changing up the arrangement of the washers. I will try to search for it later.
Re: YIKES!!
Here in Ohio the new gas taxes kicked in on July 1. An additional $.10 on regular gas and $.19 on diesel. Diesel is still a little higher than regular here.
- Fri Jul 05, 2019 3:58 pm
- Forum: Community
- Topic: Customer Support
- Replies: 20
- Views: 56463
Re: Customer Support
I agree, Dennis. Try calling Delta or Craftsman to get help on an issue with a table saw or drill press. Unless you are ordering parts, you will be wasting your time, assuming you can still get parts.