SWMBO invited one of her friends over for dinner the other day(she is very large). There was a little mishap at the dinner table. A chair back broke. It was fastened with 4 3/4in tenons. This was my repair: I drilled the broken tenons out of the chair bottom and cut the broken tenons off of the chai...
If the tenons are a little loose in the joints, a good way to snug them to glue is to take a hand plane that's sharp & make some shavings. They curl perfectly & you can wrap the tenons with them to tighten the joint. Thanks for the tip. I wanted the finial on my current project to be a fric...
A while back (within the last 3 or 4 mounts I think) there was a link in one of the threads that showed a sequence of cutting and assembling miters. It was a demonstration that showed that even if the miter cut setup wasn't exactly 45 deg. using the cutting and assembly technique a perfect square co...
A while back (within the last 3 or 4 mounts I think) there was a link in one of the threads that showed a sequence of cutting and assembling miters. It was a demonstration that showed that even if the miter cut setup wasn't exactly 45 deg. using the cutting and assembly technique a perfect square co...
The other day I found a coupon from Harbor Freight for 12 inch clamps maximum 7 per customer at $1.99 per clamp. Eureka the deal of the year:D After trucking 25 mi Thur las Vegas traffic (one way). I found the clamps also picked up some other shop essentials. You can always find essentials at harbor...
Thanks for the info Stumpbuster. Do you have the number for the other bearing? I want to replace both at the same time. I looked up the bearing you replaced and found 6003-2RS, 6003-ZZ Premium Ball Bearings, 17x35x10 for $3.73 each The 2RS is the sealed one and the ZZ is the metal shielded one. htt...
A guy I found has a ss for sale, a 50th anniv 510, with dc and bandsaw. It has never cut anything or even been assembled! While cash is an issue, he may do a trade. Meeting this pm to discuss. 1k the figure he trhough at me. Has it been harmful for the motor and drive system to sit and be immobile ...
The other day I raised the headstock to the drill press position and my 2003 SS headstock locked up. After the initial panic and obligatory expressions were uttered the diagnosis was the inner spindle bearing failed. I found that bearing types etc. have been throughly discussed. This is my take on r...